0.I suppose to build complete the Rx-78 However, I saw the Rx78 Ver Ka can be upgrade with some detail add-on modify can become cool RX-78-3 From Gundam Senki ”ガンダム戦記”
After the end I currently keep that MG Rx78 Ver Ka into the box 1st, and try build the 1/100 Gundam Exia


1. Add up simply job and being lazy state. Using the Mr cement glue + with the Green sparkler powder. "CAUTION!" stick it on Gunpla 1st before add the green sparkle powder, or else it will drop out transparent pieces. To bad I didnt take a new photo.



2.On the Top I add the Sparkler ribbon Maoziora Style ,that can viewing the color change according to the light. Purple greeny bluis. I thought it was awesome to being look...
I build up 1stly without any re-modify,only add up the ribbon. At the end I saw.. The Head original and neck design are so small and short than I expected. Then I for the start for the remodifying again..Waste my stamina (=A-)..

3.Above are there are the result I cut the neck and add the pla 2mm and inside with drilling and put the bronze stick inside the Neck to stay more steady and still.


4. the Leg skirt can`t rotate smoothly and make a nice pose coz being blocked too obvious, So I use the saw and cut it and move down 1cm from the original state. And makes it can rotate the leg without block by his own skirt.

5. Oh My Goat!? The Exia elbow rotation manufacture design is really really bad, my little brother touch it when I away go to toilet.. And 2 of it has been broken.. Wth.. Exia repair doesnt need twin hand being broken ?! What should I do?


For this reason thats makes me no choice to do, and plan for be it for Exia Repair, however~ I still blank mind to wish I would have a nice simply Exia and put on the display shelf only. but this reeason makes me keep modify and cant stop the fate for it.. Swt




6.But the Sword I already being paint quite long time to make a complete Undamaging Exia, I dont wanna to spoil the beauty of Exia lol..
And I make this GN sword with chrome reflect and even can be reflect own face. The tips I do is using the smooth cotton to smooth it before it get fully dry.
The WIP process how I work for, to render chrome effect to become the more reflection just like mirror. On that video, you can see the back side is already apply the silver with brush but havent smoothing with Soft Cotton. IF you interest and no airbrush user can try for it.
Step 1: Using the most soft Sand paper to sand your GN Sword
Step 2: clean the dirt sanding layer with the "Sponge"
Step 3: Using the Super Metalic chrome to color it with brush. Add some retarder Mild to stay lower fast drying for the paint.
Step 4. Wait it about 5 minutes to see either almost dry or not. You can touch it see neither still wet or not. If you feel already dry without not really wet, then apply the soft cotton to smoothing on it.
Step 5:Follow the direction sanding that you apply. Thats make sence to feel thats more like a Real chrome Sword.
Enjoy~


7.A Mess up of the Exia own custom repair. Dont worry, I wont make up with it. Just for fun. I will repair back my hand elbow using putty and and pla-plate to repair the hand back. I wont make Exia repair. Those 2 photo is just for fun temporarily.



































